PAGlok Cube
The new PAGlok Cube is an ultra-compact, low-cost, simultaneous fast-charger. It features PAG’s own Intelligent Parallel Charging software, designed for the safe simultaneous fast-charging of the latest PAGlok Li-Ion batteries.

Extend Battery Life
Charging is the most important factor in achieving an extended battery cycle life. PAG L95 Li-Ion Time Batteries are capable of an average of three years active service, without substantial loss of capacity, when protected from abusive charging practices.

PAGlok Compatible
The new PAGlok Cube (Model 9702) features four full-sized PAGlok connectors. The Cube can also be used to sequentially fast-charge PAGlok Ni-MH and Ni-Cd batteries.

Intelligent Parallel Charging
This high-powered charger is capable of supplying 6A at 16.8V, approximately 100W. Charging is fast, efficient and fully-automatic thanks to PAG's unique Intelligent Parallel Charging. PAG iPC software incorporates three phases:

Phase 1 Pre-Charge:
Prepares shutdown or deeply discharged batteries for charge acceptance.

Phase 2 Testing:
Determines the type and state-of- charge of the batteries, and the maximum current that can be applied.

Phase 3 Charging:
The charger then shares the current intelligently between the channels, briefly addressing the most discharged batteries first, before simultaneously fully-charging all batteries as quickly and efficiently as possible.

Information Display
The Cube incorporates a backlit LCD screen which indicates at all times the status of each channel.

Ideal Location Charger
The Cube is the ideal location charger. It is quiet and cool-running. It has a robust but lightweight impact-resistant moulded-construction, incorporating an aluminium frame. It features a strong, moulded handle that enables you to carry the charger with four batteries connected. The handle can be retracted into the lid of the charger when not required, to maintain the compact dimensions of the unit.

Future Proof
The charger is capable of receiving firmware updates via its battery connectors, without the need to open the casing, which is both convenient and economic.

Power Supply
The Cube's power supply technology enables the charger to be powered from any AC power supply, worldwide.

PAG Cube (PAGlok)

Connectors: 4 x PAGlok only

Intelligent Parallel Charging:
PAG Li-Ion batteries (latest 3-pin models)

Sequential Charging: PAG Li-Ion (older models), PAG Ni-MH & Ni-Cd batteries in the ranges 4.8V to 14.8V, 1Ah to 10Ah (not NMH60).

Dimensions and Weight:
157 x 150 x 150mm / 1.19kg

Model 9702


Use the Cube to Power Your Camera
via the PAG CPA

The Cube can be used to power your camera from an AC mains supply, with the addition of the PAG Camera Power Adaptor.

This compact, impact resistant unit can be connected to any channel on the Cube charger. Connection to the camera can be made using a PAG XLR-4 male to female adaptor, coiled lead (Model 9450).

The PAG CPA outputs up to 5.5A at 16.8V and is suitable for use with modern broadcast cameras which can be powered using 14.4V / 14.8V Li-Ion batteries.

The PAG CPA Model 9701 features a PAGlok battery connector for use with the PAGlok Cube Charger.

Specification:

Model No. 9701
For use with PAGlok Cube Charger Model No. 9702.

Input Connection:
To be powered only from the appropriate charger (see above).

Output:
16.8V DC. Maximum current 5.5A (90W).

Output Connector:
XLR-4 (F) connector (Pin 1 Negative, Pin 4 Positive).

Overall Dimensions (H x W x D):
130 x 86 x 47mm

Weight:
190g