The PAG V2 charger is a new, ultra-compact and economical 2-channel charger for V-Mount Li-Ion and Ni-MH batteries.

It has a tough but lightweight moulded-construction which makes it an ideal travel or back-up charger.

The PAG V2 is only slightly larger than a PAG L95 V-Mount Li-Ion battery and will fit easily into your camera bag.

The charger incorporates two V-Mount connectors and will sequentially charge V-Mount Li-Ion and Ni-MH batteries, manufactured by PAG and Sony.

The PAG V2 features PAG ACS software which will extend the cycle life of your batteries.

The Recovery Charge Program will automatically recover the PAG Li-Ion battery when the output has been shut down by the internal protection circuit.

The charger's user interface features a comprehensive LED indication of battery and charger status. The charger is fully automatic in operation and constantly monitors every process.

The PAG V2 can be powered from almost any AC power supply, worldwide, or from a vehicle battery with the PAG Vehicle Battery Power Converter (Model 9774).

PAG V2 Charger PDF

Specification

The PAG L95e is the industry's best value Li-Ion battery.

Unlike cheap imported batteries, the highly economic L95e maintains the high quality and safety standards for which PAG is renowned.

PAG has been able to do this by redesigning the battery to incorporate a new 5 LED capacity indicator, that also displays run-time, whilst using the same branded cell pack and electronic protection system as the L95 Time Battery.

The battery is protected against the damaging processes that reduce capacity; and in combination with proprietary charging techniques, the result is a longer cycle life. PAG is able to offer an impressive warranty of 18 months on the new L95e.

4-channel V-Series location charger featuring Intelligent Parallel Charging

The PAG Cube is a new, ultra-compact, low-cost, simultaneous fast-charger. It features proprietary Intelligent Parallel Charging software, designed specifically for the safe fast-

charging of V-Mount Li-Ion batteries, of reputable manufacture.

Extended Battery Life

Charging is the most important factor in achieving an extended battery cycle life. PAG L95 batteries are capable of an average of three years active service, without substantial loss of capacity, when protected from abusive charging practices.

V-Mount Compatible
The Cube features four V-Mount compatible battery connectors and can also be used to sequentially fast-charge PAG ZL-Series V-Mount batteries and other V-Mount Ni-MH batteries of reputable manufacture.

Economy

Value for money is at the heart of the Cube's conception. Equivalent chargers from other manufacturers can cost more than three times as much, whilst also adversly affecting battery life.

High-Power

The high-power Cube is capable of supplying 6A at 16.8V, approximately 100W. Charging is fast, efficient and fully-automatic, thanks to PAG's unique Intelligent Parallel Charging software.

PAG Intelligent Parallel Charging

This unique PAG charging software incorporates three phases:

Phase 1 - Pre-Charge: prepares shutdown or deeply discharged batteries for charge acceptance.

Phase 2 - Testing: determines the type and state-of-charge of the batteries, and the maximum current that can be safely applied.

The L95e uses five LEDs to display charge status in terms of percentage. When the display button is pressed each LED that is lit represents approximately 20% of available capacity.

The display is also capable of indicating an estimate of remaining run-time, on-load:

A second button press activates the time display. The 'HRS' LED flashes twice

The number of hours is indicated by the number of lit LEDs: 2 LEDs = 2 hours.

Power hungry high-definition equipment requires higher capacity batteries. For this reason PAG has developed and introduced a new 110 watt-hour Li-Ion battery. The 14.8V 7.5Ah PAG L110 utilises high-capacity cells and offers increased run-time with no increase in size or weight.

Shoot All Day
Two L110s can provide enough power for a days shooting, depending on the camera, and lighting requirement. They are small and light enough to be carried in your camera bag.

Compact Power
The PAG L110 shares the same impact-resistant casing and advanced internal features as the L95. PAG’s unique electronic protection system guards against the damaging processes that reduce capacity and is itself protected against the effects of internal damage.

Life Guaranteed
The combination of PAG’s protection system, and its proprietary charging techniques, prolongs battery life. It enables the company to guarantee the L110 for two years.

Unbeatable Compatibility
The L110 is available in models that are compatible with the three major mounting systems: V-Mount, PAGlok, and Snap-on. PAG is the only manufacturer able to offer this level of compatibility.

Specifications:

PAG Cube Charger

Model No. 9702V

Battery Connections:
4 x V-Mount compatible connectors.

Range of Batteries Charged:
PAG V-Mount Li-Ion: L95 (Models 9360, 9335V) L95e (Model 9310V), L110 (Model 9302V).

PAG V-Mount ZL-Series: ZL-150, ZL-125 and ZL-50 (Models 9316V, 9317V and 9315V).

Sony V-Mount Li-Ion and Ni-MH.

IDX V-Mount Li-Ion.

Main Charge Programs:
Li-ion Intelligent Parallel Charging program: maximum output 6A at 16.8V (100W approx.).

PAG ACS Ni-MH sequential charge program: output 3A.

Recovery Feature:
Automatically recovers a Li-Ion battery where the output has been shut down. Additionally, the program detects batteries having a very low voltage, and initiates a special low charge current.

The program will operate until the voltage has risen sufficiently for batteries to safely accept the normal charge current.

Self Test Program:
The internal microcomputer constantly monitors the battery under charge or process as well as the operation of the charger’s own functions which will be shut down to a safe condition should any of the tests fail.

Mains Input:
90V to 265VAC. Frequency 50-60Hz. EN6100-3-2 Power factor corrected. Maximum consumption 140W.

Output Protection:
Charger protected against short circuit and excess battery voltage.

The L95 Time Battery combines power, accuracy and reliability, and is the industry’s most advanced battery.

The introduction of the V-Mount compatible L95 Time Battery means that PAG is the only manufacturer that offers its premier digital Li-Ion battery in the three most popular formats: PAGlok, V-Mount and Snap-on (Anton-Bauer).

The L95 embodies advanced Li-Ion cell-technology that combines a 95 watt-hour capacity with a weight of only 745g. This means more run-time for both a camcorder and a light up to 35W. Two batteries provide enough power for a days shooting, and can be stowed in your camera bag. The capacities of two V-Mount L95s can be combined, to provide a higher current draw capability and longer run-times, by using the PAG V-Mount Power Plate.

One of the major advantages of the L95 Time Battery is PAG’s unique Power & Time Display. It shows remaining camera run-time, counting down in 1 minute increments, which is updated against changes in load. The easy-to-read digital character display also shows available capacity in 1% or 0.1Ah increments. PAG is the only manufacturer to offer this level of accuracy.

Power Your Camera Using the
Cube Charger

The V4-CPA Camera Power Adaptor, available separately, enables you to power your camera from an AC mains supply, using the Cube charger.

The V4-CPA, Model 9701V, is housed in a compact, impact resistant case and can be connected to any channel on the Cube charger.

Connection to the camera can be made using PAG Adaptor Model 9450, XLR-4 male to female (coiled lead).

The V4-CPA outputs 16.8V at 5.5A and is suitable for use with modern broadcast cameras which use 14.4V and 14.8V Li-Ion batteries.

The V4-CPA can only be used in conjunction with the PAG Cube or V4-iPC Charger.

PAG V4 Camera Power Adaptor PDF

Specification

The many levels of protection built into PAG Li-Ion batteries prevent the damaging processes that reduce capacity; this, combined with proprietary charging techniques, ensures a longer battery cycle life.
It enables PAG to offer a warranty of 2 years on the L95 Time Battery.

PAG L95 Time Batteries have been rigorously tested by an independent, authorised facility, to comply with United Nations regulations. This is a legal requirement of air transport and civil aviation authorities.

To ensure the longest possible cycle life V-Mount L95s should be charged with PAG chargers. Both 2 and 4 channel V-Series chargers are available that incorporate V-Mount battery connectors.

It is possible to charge V-Mount L95s via the front PP90 sockets of all-chemistry PAG chargers (AR Series 2, Quasar and Pulsar) using charge adaptor Model 9617.

The V-Mount L95 can also be charged using suitable Sony chargers.

Upgrades could include the facility to charge other cell-chemistries, if required.

The charger is both quiet and cool-running during operation. It has a lightweight but robust, impact-resistant moulded construction which makes it ideal for location use. The unit can be carried with the batteries connected.

A large, backlit LCD screen provides a continually updated display of battery and charger status, indicating at all times which batteries are receiving charge, the charge current and the battery voltage.

The latest PFC power supply technology enables the PAG V4-iPC Charger to be powered from any AC power supply, worldwide.

Specification

A new four-channel charger for
V-Mount Li-Ion and Ni-MH batteries.

The PAG V4-iPC Charger features the company's own fully-automatic and highly-efficient Intelligent Parallel Charging regime, which incorporates
3 phases:

Phase 1 'Pre-Charge' prepares shutdown or deeply discharged batteries for charge acceptance.

Phase 2 'Testing' determines the type and state-of-charge of the batteries, and the maximum current that can be applied.

Phase 3 'Charging' shares the charge current intelligently between the channels, to provide usable capacity as quickly as possible, and achieve four fully charged batteries in the most efficient way.